--

 Return to Index  

roller lifter interference

April 26 2006 at 4:35 PM
No score for this post		   (Login lincparts)
from IP address 209.242.168.129
 

I installed an isky roller cam, roller rockers, roller lifters into my '63 430 (bored.60 over). I saw a post on another forum that stated interference issues with cylinders 3,4 lifters hitting the valley pan baffle. Has anyone any knowledge of this ? My next question is with this is are the stock spirngs acceptable for this cam (.505 lift), knowing that this motor isn't going above 5000 rpm? Are there other pitfalls to my project before I have the motor installed? Thanks, Lincparts

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Responses

  1. roller set -Isky - Anonymous on Apr 26, 5:15 PM
    1. Don't use stock MEL springs..... - Theo on Apr 27, 1:48 PM
     
  2. Pan Interference - KULTULZ on Apr 28, 4:50 AM
    3.  
  3. info on interference - lincparts on Apr 28, 9:30 AM
    1. Hand Crank... - KULTULZ on Apr 29, 7:40 AM
     
  4. 430 Linc Cams Delima - Brian perrenot on May 11, 8:46 AM
    1. My Understanding Is... - KULTULZ on May 12, 3:05 AM
      1. 430 Cam Beraing Journals - BPerrenot on May 12, 6:38 AM
        1. I Was Hoping Someone Else Would Jump In... - KULTULZ on May 13, 1:59 PM
          1. 430 Cam's / Bearings - BPerrenot on May 15, 6:36 AM
            1. AHA! - KULTULZ on May 16, 2:35 AM
              1. Cam Journal Sizes - Brian on May 16, 8:03 AM
                1. Things Are Starting To Fall Into Place - KULTULZ on May 16, 3:57 PM
                2. On Continuing Learning Curve - KULTULZ on May 17, 6:07 AM
     
Find more forums on CarsCreate your own forum at Network54
 Copyright � 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  
Neue Seite 5
     
  The MEL Engine  Knowledge Base        The MEL Photo Section       Orig. FE Big Block Forum        FE Big Block Forum     Other Cool Links  

go back to page 1 of   The (MEL) 383, 410, 430, 462 cid Engine Forum