Fresh MEL build

brechlrl · Post by **brechlrl** » Sun 8. Dec 2013, 09:40

I just broke in the cam on this engine It is a 515 inch ported heads 10.5 compression with a Slover adapter and a Performer RPM from a 460.

It should make about 525 horse and close to 600 lb of torque. It will be on the dyno in the next few weeks

Post by **Shelby#18** » Sun 8. Dec 2013, 20:43

That looks pretty darn awesome!

Post by **Theo** » Mon 23. Dec 2013, 04:10

Ooooh, yes

brechlrl · Post by **brechlrl** » Fri 24. Jan 2014, 15:50

Here are the dyno results form the 517 motor. It was built with torque and pump gas in mind.. Lots of torque here

vanscooter · Post by **vanscooter** » Fri 24. Jan 2014, 19:07

Great job !!!!!! Is the crank an offset grind for stroke ? What are you putting it in ?

brechlrl · Post by **brechlrl** » Sat 25. Jan 2014, 08:36

So far I do not have a car to put it in. I just like building motors lol

The crank is offset ground to a 4.21 stroke and uses a 2.2" BBC rod bearing

vanscooter · Post by **vanscooter** » Sat 25. Jan 2014, 13:10

Thanks. Saw you on the FEForum

Post by **Theo** » Fri 31. Jan 2014, 12:34

: thu.jpeg (5.6 KiB) Viewed 15011 times

Treinarts · Post by **Treinarts** » Wed 12. Feb 2014, 09:11

Impressive. What cam are you running? Nice flat torque curve. TJR

brechlrl · Post by **brechlrl** » Sat 22. Feb 2014, 18:34

Cam was ground by Jones Cams in North Carolina on a blank that I found years ago. It is hydraulic and a 244/244@ .050 and .500 lift.

Fresh MEL build

Fresh MEL build

Re: Fresh MEL build

Re: Fresh MEL build

Re: Fresh MEL build: Results

Re: Fresh MEL build

Re: Fresh MEL build

Re: Fresh MEL build

Re: Fresh MEL build

Re: Fresh MEL build

Re: Fresh MEL build

Who is online