--


  << Previous Topic | Next Topic >>Return to Index  

fabracated intake manifold

July 9 2008 at 12:11 PM
No score for this post		   (Login treinarts)
from IP address 140.239.87.194
-
I am having a high rise single four barrel intake manifold made up. Costs will be greatly reduced if several are made. Manifold will be like those at Lakewoodheaders.com. Steel
Can get six manifolds for 2000. Cost for each would be 334 dollars. Any body interested? TJR

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply

(Login KULTULZ)
MEL Forum Moderator
69.140.42.35

Are These Sheet Metal...

No score for this post		July 20 2008, 3:02 AM 

...single plane?

Here is a better option (IMO) if one could find a reasonably priced quality welder...



This shows a 460 single plane welded to adaptor plates but a two plane (for street) should not be that difficult.

 
Scoring disabled. You must be logged in to score posts.Respond to this message   

(Login lesparker)
76.25.80.105

Intake

No score for this post		August 9 2008, 4:42 PM 

I would be interested in an intake manifold, if still available...

lesterparker@comcast.net

Thx,

Les

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Current Topic - fabracated intake manifold
  << Previous Topic | Next Topic >>Return to Index  
Find more forums on CarsCreate your own forum at Network54
 Copyright � 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  
Neue Seite 5
     
  The MEL Engine  Knowledge Base        The MEL Photo Section       Orig. FE Big Block Forum        FE Big Block Forum     Other Cool Links  

go back to page 1 of   The (MEL) 383, 410, 430, 462 cid Engine Forum