--


  << Previous Topic | Next Topic >>Return to Index  

u-fab-manifolds

May 16 2007 at 10:52 AM
No score for this post		   (Login 00llama)
from IP address 69.106.78.9
-
Due to unavaibility of aluminum intakes it appears it is necesary to make one. Anybody know of any u-fab manifolds or kits out there? TJR

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
AuthorReply

(Login KULTULZ)
MEL Forum Moderator
69.140.42.35

None That I Have Seen

No score for this post		May 17 2007, 4:28 AM 

I have seen photos of 460 uppers modified to fit. These were single plane though.


 
Scoring disabled. You must be logged in to score posts.Respond to this message   

(Login 00llama)
69.106.78.9

manifold

No score for this post		June 13 2007, 1:00 PM 

I cannot identify the intake in the picture. It is not a 460 Edelbrock Victor as the runners in the picture are straight and the Edelbrock 460 has curves. Help? TJR

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Current Topic - u-fab-manifolds
  << Previous Topic | Next Topic >>Return to Index  
Find more forums on CarsCreate your own forum at Network54
 Copyright � 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  
Neue Seite 5
     
  The MEL Engine  Knowledge Base        The MEL Photo Section       Orig. FE Big Block Forum        FE Big Block Forum     Other Cool Links  

go back to page 1 of   The (MEL) 383, 410, 430, 462 cid Engine Forum