--

 Return to Index  

Reground Camshaft

May 20 2004 at 4:45 PM
No score for this post		   (Login KULTULZ)
MEL Forum Moderator
from IP address 69.140.62.242


Response to Pistons and cranks
Is the shop going to change the events on the cam or just return it to OEM? If only return, you most likely will not need a regrind.

 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Responses

  1. Regrinding a cam is usually a clean up of the lobes........ - Theo on May 20, 5:59 PM
    2.  
  2. Re: Reground Camshaft - jc on May 21, 11:39 AM
    1. Hey that's interesting.......... - Theo on May 21, 1:26 PM
    2. Hi JC - Anonymous on May 21, 3:57 PM
      1. Re: Hi JC - jc on May 21, 6:47 PM
      2. Honing Plates - KULTULZ on May 22, 7:39 AM
        1. These odd honing plates would probably cost a $... - Theo on May 22, 2:45 PM
          1. Cost of Plates - KULTULZ on May 22, 3:07 PM
            1. Oh, torque plates are essential.... - Theo on May 22, 3:14 PM
      3. Re: Hi JC - jc on May 24, 8:10 PM
        1. Hi JC - JL on May 26, 6:39 AM
          1. Re: Hi JC - jc on May 27, 11:45 AM
     
Find more forums on CarsCreate your own forum at Network54
 Copyright � 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  
Neue Seite 5
     
  The MEL Engine  Knowledge Base        The MEL Photo Section       Orig. FE Big Block Forum        FE Big Block Forum     Other Cool Links  

go back to page 1 of   The (MEL) 383, 410, 430, 462 cid Engine Forum