--

 Return to Index  

Not Too Difficult

August 14 2003 at 4:17 PM
No score for this post		   (Login KULTULZ)
MEL Forum Moderator
from IP address 68.50.36.202


Response to That's the one, except.........
 

The snout has to be clean and deburred. I simply tap the sleeve on with a small block of wood.

Come to think of it...It wouldn't be that difficult to make an installation tool (press on) from a balancer installer.

You would have to use the oversize seal...the only trouble is it comes in a kit with the sleeve, seal and front cover gasket.

I Am Presently Looking For Any Factory/Aftermarket Parts/Information Regarding The MEL Engine Series

Also Older FORD Special Service Tools


 
Scoring disabled. You must be logged in to score posts.Respond to this message   
Responses

  1. The sleeve I got is for an FE....... - Theo on Aug 14, 11:25 PM
    1. Front Seal... - KULTULZ on Aug 15, 7:37 AM
     
Find more forums on CarsCreate your own forum at Network54
 Copyright � 1999-2009 Network54. All rights reserved.   Terms of Use   Privacy Statement  
Neue Seite 5
     
  The MEL Engine  Knowledge Base        The MEL Photo Section       Orig. FE Big Block Forum        FE Big Block Forum     Other Cool Links  

go back to page 1 of   The (MEL) 383, 410, 430, 462 cid Engine Forum