This item has been added to My eBay for Guests. As a guest, you can: Track up to 10 items on this computer in My eBay Receive an email reminder for this item a few hours before it ends
You are bidding on a very custom built intake system that will fit any Ford FE series motor. This starts with a new, aftermarket DOVE copy of the infamous TunnelWedge Intake manifold that has been mildly ported to match the Victor Reinz MS15166X intake gasket (Medium Riser-Edelbrock). Next are 2 new custom built 750cfm carburetors that use Proform center sections, Holley HP metering blocks, new Holley fuel bowls and baseplates. All hardware is either genuine Holley or ARP. Now for the custom stuff.
Billet 1/2" mounting plate that turns both Holleys sideways on the intake
Aeromotive 4 port fuel regulator
All plumbing is done with Earl's Pro-lite hose and matching fittings
Custom carburetor spacers
2 Billet bellcranks to operate the Holleys
Carbon Graphite throttle linkage-heim joints
ARP stainless steel mounting hardware
I built this with the intention of using it on a 480ci 427 but have since altered my plans to use Tunnel Port items. Bid with confidence as this is a one of a kind system. All components are new and have never had fuel in them. Check out my feedback, I don't sell junk. Shipping will be UPS ground and will be determined at the end of the auction, irregardless of what the shipping calculator says. Shipping is FREE if the 'buy it now' is used. If you intend to bid but live outside of the US, please email me first to make sure that I will ship to your country. Please ask questions as I'm sure I'm leaving important information out. Thanks for looking and have a nice day!
On Nov-30-08 at 17:55:59 PST, seller added the following information:
MSD billet distributor is not included in the auction. It shows plenty of room between a large cap distributor and the primary carburetor. Sorry for any confusion.
Select a picture
00371
Questions from other members
Q:
have the intake surface faces been milled down? Do you have the removable bottom plate?
Answered on Dec-05-08
A:
Nope, zero milling on any intake surface and yes, the removable bottom plate is included. Thanks for the question.
Q:
could i ask where you got the carb linkage set up from. Nice.
Answered on Dec-02-08
A:
My design but build by a local CNC job shop. Thanks for the question!
*Sellers are not responsible for service transit time. This information is provided by the carrier and excludes weekends and holidays. Note that transit times may vary, particularly during peak periods.
Track up to 10 items on this computer in 
)
)
w!eBJMzC9yVt!~~_0.JPG)
